Yes I have seen the drawing.... and some of it is doable. The Front Fender that we did almost has to stay that way so that it remains a clean straight line until you get to the headlight just no other way to get close. You cant go any higher on the doors as the line from back qtr panel will not line up with the tail lights and rear hatch.
Now the Trim you want to go above the doors and near pillar trim is prolly doable but you have to remember the widest wood grain trim we make is only 1 inch wide. Reason for that .. the wider it is the harder it is to work with and make any kind of turn.
Also any trim you want to put Vertical along the door edge is just a matter of adding extra trim. The lines you see on the one we did for Scion pro is just buckskin pin striping .. purely optional although I wouldnt suggest it if you were using trim on the vertical door lines.
Hope this helps a little anyways
http://www.ptwoody.com/ts007.html this one might be little closer to what u were looking for but doesnt have fender pcs
Kevin
Woody Wagoon
